Fusée de Tintin V2

Here is the Tintin's Rocket 2nd Version (After many modifications)
It's 17.5 cm high (6,90 inch)

Instructions : Print the rocket piece after piece while paying attention to the order of the rings.
One ring is composed of two pieces : a white part and a red part
To assemble the both, you have to follow an order, the white at the top and the red at the bottom.
So you have to pay a lot of attention of this and if you assemble the good red part and the good white part.
To print the low part, print it in reverse way, on the plane surface.
As this surface isn't very big, you should add adhesion.
To finish, glue all the piece together. CA glue is perfect.

Good Luck !

The modifications of the previous one :
- Play between the two parts of the rings to assemble them easier.
- The three orbs of the base are in the same piece and don't need to be assembled
- More of contact surfaces between wings and the rocket to decrease risks of breakage.