Fusuit Pacifier - With Interchangeable Buttons

Highly inspired by RiNax's Fursuit Pacifier but with one major change. The bolt has been replaced by a screw and nut system.
This allows quick swapping of buttons, without needing to reprint the entire pacifier.
Please note that this is not for people and is only for use as a prompt.

Instructions

1. Print a Nuk, D-ring, Shield, and Button
2. Remove Supports and extra filament
3. Clip the D-ring into the Button (use hot water so it's more flexible!)
4. Place the Button on the Shield and screw the Nuk on from the other side.

Updates
V1.1

Added v2 versions of Nuk and Shield
Old Versions were not removed as the versions are not inter-compatible
V2 versions have improved thread strength on Nuk

V1

Initial Release