Thingiverse
Fuzz enclosure
por Rusty_Olli
5
Descargas
7
Likes
0
Makes
I have made this enclosure to house a FuzzF type circuit with a true bypass switch (3PDT).
The one I printed has had a layer of Epoxy resin over it, this has helped to stiffen up the enclosure. It has a lip and groove on the lid and base with a hole in the centre of the lid for an M3 brass insert to be melted in. This single screw with the lip and groove is enough to secure the two halves together.
The one I printed has had a layer of Epoxy resin over it, this has helped to stiffen up the enclosure. It has a lip and groove on the lid and base with a hole in the centre of the lid for an M3 brass insert to be melted in. This single screw with the lip and groove is enough to secure the two halves together.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!