Fuzzy Blobs Lid for my Boxes

Hey there, the Jewelry Box “Lid” - Fuzzy Blob is here! Here is a new lid for my stackable jewelry boxes. My goal was to create a unique lid using a single-color print. By placing the lid at a 45-degree angle, I was able to achieve this. It combines two printing techniques. I had no issues during printing, but I’d like to point out that the print bed should have proper adhesion. If you encounter any problems during printing, feel free to let me know which printer and material you used to print this lid. After printing, you can remove the supports and smooth the supported side using a deburring tool or scraper. Afterwards, I use a jet flame lighter to briefly go over the deburred areas to ensure a nice finish. I wish you lots of fun with the printing, and let me know if you like this type of lid :) Used filament from the brand PolymakerPanchroma - Muted BlueBoost MeIf you like the model, I would appreciate it if you could take the time to like, follow, or boost it. That helps me continue