Thingiverse
FX Impact monopod
par KMonroe
32
Téléchargements
14
Likes
0
Makes
This uses a lead screw similar to saber tactical mono pod.
printed in PETG at 25% fill
use small screws to hold lead screw nut into PETG
lead screw does not fit into cold base nob. Heat up screw with torch and screw into nob, it will bond tight. Not too hot! UPDATE: Knob 2 has round base and is better.
There is a hole for lock bolt for lead screw but i found i don't need it.
buy lead screw on amazon. here is one link
https://www.amazon.ca/Pomya-Threaded-Trapezoidal-Stainless-Printer/dp/B07SL99T2X/ref=sr_1_12?crid=3G93H93GWJJMY&keywords=8mm%2Blead%2Bscrew&qid=1655525891&sprefix=8mm%2Caps%2C129&sr=8-12&th=1
very pleased so far.
printed in PETG at 25% fill
use small screws to hold lead screw nut into PETG
lead screw does not fit into cold base nob. Heat up screw with torch and screw into nob, it will bond tight. Not too hot! UPDATE: Knob 2 has round base and is better.
There is a hole for lock bolt for lead screw but i found i don't need it.
buy lead screw on amazon. here is one link
https://www.amazon.ca/Pomya-Threaded-Trapezoidal-Stainless-Printer/dp/B07SL99T2X/ref=sr_1_12?crid=3G93H93GWJJMY&keywords=8mm%2Blead%2Bscrew&qid=1655525891&sprefix=8mm%2Caps%2C129&sr=8-12&th=1
very pleased so far.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !