Slicer Discord
G-Code Disable Power Loss Recovery – Modèle 3D imprimable de MakerWorld MakerWorld
Test Models

G-Code Disable Power Loss Recovery

0 Téléchargements
1 Likes
0 Makes
Voir le modèle
https://wiki.bambulab.com/en/knowledge-sharing/power-loss-recovery While it is a handy feature, it can also cause a number of issues, some of which are noted in the above wiki, but also excessive writes and wear on the Micro SD Card, the P1 series are known for burning through SD Cards and it is suspected that this feature can be part of the cause.The feature can be switched off early-ish in the print, which should reduce the wear on the SD card.To do this, edit the printer settings in Bambu Studio and insert the following into the start of the Time Lapse G-Code.{if layer_num == 1} ; close powerlost recovery M1003 S0{endif}
Catégorie
Test Models
Source
MakerWorld
Publié
Mis à jour
Ce qu'il faut pour imprimer: Débutant Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 0/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection