Slicer Discord
G-Rap 3D Printer: Powered by Printrbot – 3D-printbaar model van Thingiverse Thingiverse

G-Rap 3D Printer: Powered by Printrbot

door GWP17
84 Downloads
104 Likes
1 Makes
Model downloaden
ADDED Solidworks files (12/19/16)
ADDED Cura Profile

This is the set of files for the Printrbot Frankenbot V1 with 12mm rods. Printrbot is currently not stocking the starter kit for this version, but it can easily be made in a reprap style with selfsourced parts as well. Linear blocks with press fit LM12UU or LM12UU are supported though extra parts must be printed if not using press fit bearings. A complete guide to assemble this printer can be found at: http://griffinp117.blogspot.com/2016/04/printrbot-starter-kit-v1-build-guide.html

If you would like a set of these parts printed please contact me by posting a comment below.

The printer uses all of the hardware from the original Printrbot Starter Kit V1. It boasts a build area of 10in x 8in x 8.5in (25cm x 20cm x 21.5cm) with full autoleveling.

NOTE: This thingiverse page and the instruction guide is still a work in progress. These parts are unlikely to face large amount of changes aside from the addition of holes for the
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie