Thingiverse
G29 pedal adjust
por koretic
62
Descargas
48
Likes
0
Makes
Adjustable adapter for logitech g29 pedals to have them a bit taller and a bit closer. There are two predefined versions of 10 and 15mm (15mm in picture).
Original long screws will be reused but you will need two additional short M4 screws to screw adapter to pedal mount and inserts for original screws to hold the pedal plates.
Ideally you want to print with 4+ walls, hot and low layer height if using PLA.
Original spacers are still mounted on top of this spacer so everything fits nicely.
In pictures, clutch is original while brake and throttle use these adapters.
Original long screws will be reused but you will need two additional short M4 screws to screw adapter to pedal mount and inserts for original screws to hold the pedal plates.
Ideally you want to print with 4+ walls, hot and low layer height if using PLA.
Original spacers are still mounted on top of this spacer so everything fits nicely.
In pictures, clutch is original while brake and throttle use these adapters.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!