Slicer Discord
G80 Valve controller plugs – 3D-Druckmodell von MakerOnline MakerOnline
G80 Valve controller plugs – Bild 1 G80 Valve controller plugs – Bild 2 G80 Valve controller plugs – Bild 3 G80 Valve controller plugs – Bild 4 G80 Valve controller plugs – Bild 5
Hobby&DIY

G80 Valve controller plugs

von Leinad · Hobby&DIY
20 Downloads
4 Likes
0 Makes
Zum Modell
This will close the plugs in the trunk of your G8X if you are running a valve controller. This prevents bugs, debris, etc from entering your battery compartment/trunk. Its split in half so that you can feed the wires through without removing them from the controller module. Some double sided 3M tape on the backside of the lip or some glue will affix it. It is a TIGHT fit to get them in so that they don't rattle and effectively seal. You have to put on part in, then angle the other upward, slide in and press. 
Kategorie
Hobby&DIY
Quelle
MakerOnline
Veröffentlicht
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Kleben
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen