Gabotronics Xminilab Case

This case will help better protect your Xminilab.
Designed for .115 cast acrylic, measured to .12
My cutter recognizes red as cut, and blue as etch.
The latest firmware basically removes the need for PDI


First cut 1.0 - (fits tight)
Revision 1.1 - (getting close)
- expanded the inside by .01 in all dimensions to better fit the scope
- minor corrections in layout
- clearanced case for micro USB plug
- added pin information text
- added a score mark for a bent pin design
Revision 1.2 - (not tested)
- added more room for the bent pin design
- centered the USB plug area
- added keys on upper edge
- centered bolt holes better
- added (flimsy) cover around usb plug

Photos are of 1.0 and a test fit of 1.1
I used acetone to melt my acrylic together, and servo plugs to connect my channels to hook clip probes.
Im happy with Rev1.1, but Rev1.2 should make it better