Game Blu-Ray Rax

While tidying up my TV setup, I realized I needed a better way to store my PlayStation games (Blu-Rays). Most of the existing options I found were either too bulky, used excessive filament, or weren’t designed to hold many games efficiently. So, I decided to design my own solution. I focused on keeping it as lightweight as possible without compromising strength, just sturdy enough to keep the games standing upright. I also made the stand slightly shorter than the game cases so it stays discreet and nearly invisible when in use. Because of the invisible profile I printed mine in Draft mode and they came out more then good enough, this made the print time even shorter. I created three versions to suit different needs: a 5-slot, a 10-slot, and a 14-slot model—the largest size I’d comfortably print on the A1. If you want you can glue the sides together but i noticed it's not even necessary if the back is against a wall. Note: Movie Blu-Rays are a bit thinner and will sit a bit loose un