Gantry Holder

While Upgrading my CR10 S5 I noticed that people would put retractable pullys on top of the gantry to manage their cables from the hot end. The printer is large and little things like this help. So, I decided to make one that is on V Rollers that slides across the top. This helps it stay in line with the hot end and holds the filament run out sensor.

Just a small quality of life upgrade.

You will need 2 M5 x35mm bolts and one x40. If you do not use the triangular plate you can get away with 25mm M5 bolts. The only reason I use a x40mm bolt is to use a nylock nut on the bottom bolt.

You need 3 spare V rollers or 3d printed V rollers (not included). There will not be a lot of strain on the setup so you don't need purchased rollers and bearings, it just helps it operate smoother.

This can be installed on any printer with a 2020 rail on top. Most Creality printers are designed like this, so it works with most Creality printers.