Thingiverse
Gap and Line Tester
von kohjbeng
1
Downloads
0
Likes
0
Makes
This is a test model so that you can print and measure what your printer's gap and line performance is.
The Gaps and Lines is from 0.2mm to 0.6mm
The actual outcome depends on the 3D Printer, the Filament, the Process used, and the Slicer (e.g. slicer may not "slice" a 0.2mm line).
After printing, use a caliper to measure what the respective gaps and lines are that you can achieve with the settings used. This is for your future reference, when you have to design you models so that they can be printable and your designs realised.
The Gaps and Lines is from 0.2mm to 0.6mm
The actual outcome depends on the 3D Printer, the Filament, the Process used, and the Slicer (e.g. slicer may not "slice" a 0.2mm line).
After printing, use a caliper to measure what the respective gaps and lines are that you can achieve with the settings used. This is for your future reference, when you have to design you models so that they can be printable and your designs realised.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
