Garbage Bag Holder (simplified)

This is mishkin2's Garbage Bag Holder with the internal structure and recycling logo removed. All that ribbing is a waste of filament, when you can print a solid part with infill instead.

PrusaSlicer settings I used:
- 2 walls
- 10% gyroid infill
- 0 skirt loops (otherwise it didn't fit on my print bed)
- Snug supports with 5mm pattern spacing
- Don't support bridges: unchecked (i.e. do support bridges)

I actually used Organic supports, but some were knocked off mid-print. Snug looks more reliable, and 5mm spacing keeps filament usage similar to Organic. I would also try a 90 degree Pattern angle, so it makes a nice S curve.

Review: This model doesn't do a good job of holding the bag open. The top surface requires supports, so it prints rough, and gets grimy with food unless you sand it well. I've since designed https://www.thingiverse.com/thing:6952639 for our kitchen.