Garchomp - Bookmark / Portrait

Story:Haven't done any Pokemon for a while. Hope everyone enjoy these new additions. I had a blast seeing them come to life. I normally do 4 Colors, but some of these will need 5 Colors to get that vibrancy. I also had to use Matte White on a couple of them to get the transitions. I usually stick with Bambu Basics, but to do better prints, I will incorporate Matte White(Lower TD) on occasion going forward. Make sure to print with Matte White when referred to or your prints will bleed the other colors beneath them. I can use Jade White, but the prints will be too thick and look unnatural. Garchomp BookmarkPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 47x150mm Can be resized to accommodate your printer or preference by adjusting the X and Y axis the same percentage while leaving the Z axis at 100%. The best way to achieve this: With Uniform Scale checked, adjust the Y axis to the desired size (this will ensure the X axis is the same propor