Thingiverse
Garden Dripper
von edgar_cm
2
Downloads
1
Likes
0
Makes
Dripper for automatic dripper system.
This connects to a 5 mm tube.
The drippers allow a 1.5mm flow from the system.
The spike allows the water to flow below the surface.
The barbs hold the dripper in place.
One end is flat, the upper is triangular to facilitate 3d printing.
One is a serial connector, the other is an end.
This connects to a 5 mm tube.
The drippers allow a 1.5mm flow from the system.
The spike allows the water to flow below the surface.
The barbs hold the dripper in place.
One end is flat, the upper is triangular to facilitate 3d printing.
One is a serial connector, the other is an end.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
