Slicer Discord
Garden Hose Guide – 3D-printbaar model van MakerWorld MakerWorld
Garden

Garden Hose Guide

door jetpad · Garden
1.3k Downloads
765 Likes
811 Makes
Model downloaden
Keep your hose on track and your plants intact. This two-part guide stakes deep beside a bed and lets the hose roll past without crushing stems.Prints in two piecesStake prints flat / horizontal for maximum cross-layer strength.Glide prints upright and spins freely once pressed onto the stakeExtra-long stake (≈ 320 mm) – holds firmly in soil so it won’t pop out when the hose pulls.Low-friction glide – rotates as the hose moves, reducing drag, tangles and kinks.Outdoor-ready – PETG recommended for UV- and moisture-resistance.Where it helps – borders, lawns, greenhouses, raised beds, allotments.Note: For best results, use a rubber mallet to drive the stake into the ground. If the ground is very hard, consider printing the stake with a higher infill density for added strength.
Categorie
Garden
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA, PETG
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

jetpad publiceert ook op

30 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie