Thingiverse
Garden Sprayer
von Carapovich
0
Downloads
1
Likes
0
Makes
A garden sprayer with a screw-on tap (or without a screw-on tap) with a 3/4" male thread at the end. The sprayer plate is dismountable for easy maintenance.
The basic nut and sprayer nut fit too tightly, so for these models, adjust the hole compensation factor in a slicer to approximately 0.3 mm.
A 3/4" rubber gasket can be found at a regular store, or you can try printing one out of TPU)
The basic nut and sprayer nut fit too tightly, so for these models, adjust the hole compensation factor in a slicer to approximately 0.3 mm.
A 3/4" rubber gasket can be found at a regular store, or you can try printing one out of TPU)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!