Slicer Discord
Gargoyle Hollowface – Modelo 3D imprimible de Thingiverse Thingiverse

Gargoyle Hollowface

por Zagadka
7 Descargas
12 Likes
0 Makes
Ver Modelo
This is a little hollow face illusion gargoyle. I sculpted (physically not digitally!) this face a while ago and cast a few in concrete. When I discovered Meshroom it was one of these casts I used as a test piece. It works pretty well, probably better than the video suggests as it had to be unnaturally close to the lens. If you're an old hand at miniature painting it's worth bearing in mind that your dry brushing should be reversed too ie start with the lightest tones in the most recessed areas and then get progressively darker on the ridges. (I have tried a couple of other hollow faces - a predator and grey alien - but this one works by far the best.)
Fuente
Thingiverse
Lo que necesitas para imprimir: Intermedio Baja confianza
¿Por qué?
soportes necesarios · postproceso considerable
Pieza única Soportes requeridos Tornillería requerida
Soportes 2/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 2/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Postprocesado
Pintura, Tornillería
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección