MakerWorld
Sport & Outdoors
Model downloaden
Garmin Livescope Turret Pointer
40
Downloads
20
Likes
9
Makes
I made a DIY turret for my livescope setup. I needed a point for the top to indicate which way the beam was directed. Fits an m6 bolt thru the base after I tapped it. I printed in ASA.It has two pieces so you can print it in contrasting colors. I chose black for the base and yellow for the top. Glued together. The bottom is like a “cup” so I could fit a rubber seal in there in an attempt to protect my electric motor from as much moisture.
gluFPV publiceert ook op
9 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
