Thingiverse
Gate Stopper
di Vspereira
0
Download
0
Likes
0
Makes
Door Stopper for a gate.
Made it round because as it will be on the flour, people can kick it. So, rounded (without any edges) should be less dangerous.
Pins (just need 2) to connect upper part with bottom part.
Center hole is for the screw (may need to enlarge the hole).
Will be needed to enlarge holes from pins.
Made in PLA but would be good in TPU or PTEG.
Made it round because as it will be on the flour, people can kick it. So, rounded (without any edges) should be less dangerous.
Pins (just need 2) to connect upper part with bottom part.
Center hole is for the screw (may need to enlarge the hole).
Will be needed to enlarge holes from pins.
Made in PLA but would be good in TPU or PTEG.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
