Thingiverse
Gatehunter Neo
von Dave_C_FPV
90
Downloads
113
Likes
0
Makes
The Gatehunter Neo is an all new performance frame designed for setups with 20x20 stacks and bigger motors (2207 and more). Using only 20x20 stacks made it possible to design this frame to be very aerodynamic and light (66g). The increase in top speed and acceleration is absolutely noticeable and it corners like there are no laws of physics holding it back ;-)
**Please note:** Be very careful to only maiden these setups in a safe open space. Especially on 6S, the betaflight stock PIDs are way too high and the flight controller might accelerate the quad uncontrolled. I recommend reducing them all by 30-40% to start with and then work you way up to da good tune.
**Frame Specs:**
- 5" stech X
- 66g including everything
- 20x20 stacks only
- 16x16 motor mounts
- 19mm cams or 14mm with adapter
- Canopy designed for Micro Axii FPV antenna
**My recommended high performance Setup**
(only 255g w/o LiPo despite the massive motors!)
- **Motors:** [Rcinpower 2207+ 1860kV](http:/
**Please note:** Be very careful to only maiden these setups in a safe open space. Especially on 6S, the betaflight stock PIDs are way too high and the flight controller might accelerate the quad uncontrolled. I recommend reducing them all by 30-40% to start with and then work you way up to da good tune.
**Frame Specs:**
- 5" stech X
- 66g including everything
- 20x20 stacks only
- 16x16 motor mounts
- 19mm cams or 14mm with adapter
- Canopy designed for Micro Axii FPV antenna
**My recommended high performance Setup**
(only 255g w/o LiPo despite the massive motors!)
- **Motors:** [Rcinpower 2207+ 1860kV](http:/
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!