Gator Grip Chip Clip

Was looking for a project to get familiar with printing Nylon, and saw a chip clip on here. Turns out that :
- Overture's EasyNylon is, in fact, super easy to print with (for real, if your machine can hit 255C, and you have a place to dry your spool, give this filament a shot!)
- The original design had some serious room for optimization.
- The fulcrum in the center did not have any centering features
- The teeth were a little close together for the material I was using
- The bite strength (spring preload as installed) was not what I was looking for, but I'm the kind of person who thinks that old school wooden clothes pins are 'about right' for clamp pressure.

So, I jumped on Solidworks and threw this variation together. The teeth are both large and progressive, favoring a bite on the leading edge of the clip, the center fulcrum makes for a nice rigid clamp, and there are a couple of different jaw clearances available to fit your machine's capability.