Gavitka Hypercube Evolution Alterations

Update: I have switched back to the original Hypercube Evolution design. I could not get the part cooling fan ducts to work properly. One duct would blow air at the bed while the other blows air directly onto the extruder cooling it off causing terrible layer adhesion. Maybe a rear mounted 5010 fan like others would work better because the Hemera hotend is off center. When I get more time I will dabble in it again but we'll see.

Here are a couple alterations I've made to Gavitka's Hypercude Evolution design. I added a BLTouch mount to the front instead of the side. I doesn't look as sharp as Gavitka's design but with the Hemera being so large it give back some X travel, still lose about 10mm, but from the other side needing clearance from the motor mount and Z rod brackets.

You can still using a P.I.N.D.A. probe, or an after market P.I.N.D.A. probe like the LJ8A3-2-Z since it's the same size diameter. You will again loose X travel distance and you'll need to set your travel limit