GB Pack Plugs

These are plugs for the shoulder straps and waist belt strap holes when removed from the Hasbro Pulse Ghostbusters Proton Pack. Installation is meant to be done from the INSIDE of the pack meaning the plastic back panel (aka. "motherboard") must be removed in order to access the inside of those voids. There are 3 different sizes of plugs required and you will need 2 of each to fill all 6 of the voids.

When installed, the cyclotron should still fit flush against the back and the plugs will be nearly flat with the motherboard. These are a friction fit and will nearly snap into place if your printing tolerances are tight, and will be held in place by either the cyclotron or the small covers at the top. Use of glue or adhesives is optional. For best results, orient the prints so that the rectangular portions of the plugs are facing the bed--this will ensure they are perfectly flat.

Infill can be kept low, 10% or less. PLA should work fine since this is not a structural part. Sand and