Thingiverse
gb22 v7
von dav88
18
Downloads
22
Likes
0
Makes
i made my gb22 v7 so that the barrel can withstand more force from the slamming of the slide into it.
the frame area where the barrel goes on is very tight and practically fused during printing but with a razor i was able to free it up so that the top and bottom spring ends apart to get the barrel on. just dont forget to put the slide and its rubber band in first (or spring that goes into the hole in the slide).
the frame area where the barrel goes on is very tight and practically fused during printing but with a razor i was able to free it up so that the top and bottom spring ends apart to get the barrel on. just dont forget to put the slide and its rubber band in first (or spring that goes into the hole in the slide).
dav88 veröffentlicht auch auf
537 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
