Thingiverse
GBS8200 / GBS-C + Analog2HDMI
door bbsan2k
6
Downloads
4
Likes
0
Makes
This is a remix of BambooShadows and s4nnis design for a GBS8200 case which includes an HDMI Cutout and mounting brackets for the Analog2HDMI converter by electron-shepherd (https://electron-shepherd.com/analog2hdmi/).
The Analog2HDMI is far superior to other HDMI converter solutions like the Wii2HDMI.
To connect, wire up the RGB, H-Sync, V-Sync and some GND contacts to the GBS8200 board for video, Audio R+L + Audio GND to the Scart input.
For 5V and GND use a 5V source on your board - in my case it is the same one that is powering the esp8266.
For mounting snap on the brackets at the top and at the bottom. Attach 4 m2 Screws from the back-side of the case in the designated screw holes.
Note:
There are 2 versions of the top bracket for the Analog2HDMI.
If you want your slicer to place the supports, please do so with the "unsupported" version.
The "supported" version has supports in place.
Print the top of the bracket upside-down.
The Analog2HDMI is far superior to other HDMI converter solutions like the Wii2HDMI.
To connect, wire up the RGB, H-Sync, V-Sync and some GND contacts to the GBS8200 board for video, Audio R+L + Audio GND to the Scart input.
For 5V and GND use a 5V source on your board - in my case it is the same one that is powering the esp8266.
For mounting snap on the brackets at the top and at the bottom. Attach 4 m2 Screws from the back-side of the case in the designated screw holes.
Note:
There are 2 versions of the top bracket for the Analog2HDMI.
If you want your slicer to place the supports, please do so with the "unsupported" version.
The "supported" version has supports in place.
Print the top of the bracket upside-down.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
