Gcode for manual bed-leveling Kossel

Procedure in Gcode for manual bed-leveling your Kossel. Comes in 6 flavours: Hot and cold bed/nozzle and 3 different bed-sizes (240, 220 and 180).

Update: 25-Oct-2019: Pyz and Pzx were swapped in earlier version. Doesn't influence the outcome but it is repaired.

The Gcode is meant for Kossels with three leveling-point in the middle between the towers. If you have the leveling-points at the corners, see note 1 below.

The codes does not print anything, only intended to adjust the bed. Start a code the same as you start a print.

The codes are available for a cold bed and for a heated bed (bed 50 degrees C, 200 C for the nozzle). The codes for the heated bed preheats the bed and the nozzle before the adjusting-procedure begins.

Follow the instuctions on screen. The Gcode jumps from point to point, and pauses in between for adjusting. Press the knob for the next point. The final Z-leveling goes slowly, so don't be afraid it will smash hard into your bed. Between the points th