GD95 Drone battery case

Diy battery pack to my (chinese gd95 from TEMU) drone.
01,11,2024 Aded new file.AKKUNEWC.stl and 3 mf
I got the right battery (socket) connector. and i did a little modification .


Attention!!!
This is not a how-to guide, this is how I did it!!!!
Its NOT a toy
Do it at your own risk!!!!
Only do it if you know what you're doing!!!!

PROTOTYPE
Stuff I used for this project,
PLA-filament , (some noname)
PCB female-header,
a piece of PCB Single Sided Circuit Board /hole board
some empty (vapor) wapor's or HQD's battery (by my Son)
(in the final version ill use PETG filament, and li-po 3.7v 750mah 602158 X2 )(or similar etc.....)
"TP4056 Charging Module" usb -"C" type
//I don't use the output on it /only for charging/
This small module's output cannot handle as many Ampers as the Drone needs and the
drone has low voltage protection, and will turn off ....etc.//


the PCB: i glued down by soldering iron /as a proto will do/
Drawn in MS. 3d-Builder
uploaded in 3mf and stl
3 different