Gear switch arm

On My 20HP J-725HP ohnson outboard engine The gearnswitch srm was broken. This arm is only available as a complete part. steel rod with heat shrinked plastic T-Split.
AsnIP'm a bit lazy I didn't want to remove the complete engine to just replace this plastic part that is on the outside so I just created a new plastic part with extremly tight fit.

Heat up the rod anfewnsec then press on the new printed part and the gear switch arm is as good as new.

There i two versions, one as original which has to be pressed on, second version is clamp version witch need a M6 screw and nut. (use this one if you don't have possibilites to heat the steel axle)


If you like what I'm doing, please consider supporting me
https://www.buymeacoffee.com/taguvove