Geeetech A10 LCD Case

[Jan 2019 Update]

Based on feedback I have made the following updates to the design.

1. Increased the size of the ribbon cable space a little and added a bevel.
2. Changed the mounting structure for the back cover to the attachment. The Mount and LCD case are now connected by 2 M4x8 screws.
3. Minor changes to the top and bottom to improve alignment, cosmetic for the most part.



A case to mount the Geeetech A10 LCD screen.

I designed this to mount on the same leg as the original using the same screws to reduce the overall footprint of the printer. I am going to see how it goes and do up some other mounting options such as one to cover the Y axis idler bearing with the screen at the very front.

The back panel without the holes can be used to cover the rear of the factory LCD mount. Just remove the screws and refit. It is slightly extended compared to the other back panel to cover the circuit board and it not compatible with the front panel included.

*** Update *