Geeetech A10 LED Light Bar

UPDATE 2/7/2019:

WARNING: PRINT IN PETG or ABS. PLA started to warp on me. Not sure if it's the heat from the bed or the heat from the LEDs being inside the housing. I am not going to re-print, as I am changing over to a Petsfang and will use the Petsfang LED bar instead to get light from the front. If you print in PETG or ABS, please post a make with your results.
------------------------------------------------------------------------------------------------------
1/30/2019:

This is a remix of the 2020 VRail LEd light, which was 220mm wide and therefore too wide to fit on the Geetech A10. I shortened it to 159mm and also made the bracket rail, on the L bar, span all the way across. This allows you to now select where the brackets attach to the L bar and to your X bar. I'm sure this would work on an Ender 3 as well, as others in the same class of size.

I printed the L bar with supports, but in reality it should print without them. Take your pick.

I will try and post pi