Thingiverse
GEEETECH A20 filament guide
von dillytious
14
Downloads
10
Likes
0
Makes
i created this very easy print to help correct the entry angle on the filament before it enters the runout sensor
you will need 2 m3x20mm bolts with nyloc nuts to mount
and an m8x40mm bolt with nut for wheel
made to fit standard 608zz bearing
you will need 2 m3x20mm bolts with nyloc nuts to mount
and an m8x40mm bolt with nut for wheel
made to fit standard 608zz bearing
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!