Geeetech E180 Flexible Removable Magnetic Printing Platform Setup

I installed the flexible removable magnetic printing platform.
After leveling the bed springs were very tightly compressed.
I bought (black) heatbed silicone buffers (18 mm high) and
reduced the "max_position [Z_AXIS]" to 124.00 mm.

I used Pronterface
- Connect Pronterface
- M2003 Z124.00 ; set new value
- M500 ; save it
- Disconnect Pronterface

Remark:
The new setting is shown in the info display.

************************************************************************************

The bed level wheel is a remix,
but thingiverse's search function didn't work to tie it all together.

https://www.thingiverse.com/thing:3061253
https://www.thingiverse.com/thing:4640419

Remark: You can install only three of them, because of the end stop switch.