Geeetech i3 Clone V2 - X axis

This is a modification of the X axis for Geeetech i3 and the modified result will need a longer X carriage GT2 belt, the original one will be a few centimeters short.

The x rods are placed horizontally instead of vertically and the extruder is turned into a Bowden setup. It fits original printer's Z interaxis and larger as it is adjustable in that direction.

The belt and motor are rotated 90 degrees too.

Interaxis of X axles is 45mm.

The belt locking plate and extruder cooling case should be glued together to the bearing support to insure they will not come loose (I still didn't glue it and didn't came loose even after many prints, but I suggest glueing...)

The Z low endstop has an adjustable plate to fix it on the original plate, but the trigger now is the step motor lower side of the body (this may need some fiddling as my printer is a bit modified so I cannot test it).
The x carriage has accomodation for X min end stop screw if you want to keep it further away from