Thingiverse
geeetech i3 pro c layerfan
von matias918
6
Downloads
4
Likes
0
Makes
layer fan for a geeetch i3 pro c dual extruder.
theres 3 files
1: holder.stl this file its mandatory to use one of the others. is based for use on the stock mounting place and allow to relocate the extruder fan a bit higher. it use the stock m3 screws and nuts.
2:the file Soporte_fan_50mm con ducto.stl it use a fan 50x50mm and it has the angle to get it very close to the nozle with out toching the printed pizes or the bed.
3:the Soporte_fan_50mm sin ducto.stl its a fan support only to get a general ventilation to the printing area.
in both cases i used the m3 screw and nuts , those came as speare on the diy kit.
theres 3 files
1: holder.stl this file its mandatory to use one of the others. is based for use on the stock mounting place and allow to relocate the extruder fan a bit higher. it use the stock m3 screws and nuts.
2:the file Soporte_fan_50mm con ducto.stl it use a fan 50x50mm and it has the angle to get it very close to the nozle with out toching the printed pizes or the bed.
3:the Soporte_fan_50mm sin ducto.stl its a fan support only to get a general ventilation to the printing area.
in both cases i used the m3 screw and nuts , those came as speare on the diy kit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
