Thingiverse
Geeetech I3 Pro Mosfet Mount
door faultedlogic
2
Downloads
2
Likes
0
Makes
This is a simple external MOSFET mount for the Geeetech I3 Pro acryllic printers.
It attaches on the back side of the printer with the nut from the 10mm threaded rod nearest the control board. Simply loosen the nut, slide the flat washer back 3mm, slide the mount on, then tighten the nut. The MOSFET attaches to the mount with the 4 pushpins included with this design.
I added a wire thruway that will attach to the other sides threaded rod for bringing the 12v wires over from the power supply to the MOSFET to tidy things up.
It attaches on the back side of the printer with the nut from the 10mm threaded rod nearest the control board. Simply loosen the nut, slide the flat washer back 3mm, slide the mount on, then tighten the nut. The MOSFET attaches to the mount with the 4 pushpins included with this design.
I added a wire thruway that will attach to the other sides threaded rod for bringing the 12v wires over from the power supply to the MOSFET to tidy things up.
faultedlogic publiceert ook op
284 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!