GeeeTech LCD bracket for Printrbot Play

Bracket for a cheap (Chinese) Geeetech Ramps 1.4 LCD controller to mount it on the Printrbot Play (http://www.geeetech.com/reprap-ramps-v14-smart-2004-lcd-controller-with-adapter-p-615.html)

Please note there is also an official Printrbot LCD controller which will no doubt fit better. But printrbot's shipping is so expensive to Europe so it was a bit cost-prohibitive. And it looks like it's out of stock at the moment.

I mounted it on the right-hand side panel because it's easy to route the cable from there (the printrboard is at the bottom of this panel). I usually have it on a table so the 45 degree angle gives me a good view of the LCD. I briefly considered putting it at the front below the print bed but the bed would obstruct the view when it moved. This way isn't really ideal either because the controller is wider than the printrbot play is deep, but it does the job and the existing screwholes make for easy and solid mounting.

The support on the right-hand side is bigger t