Thingiverse
Geekworm P252 Raspberry Pi Case Mounting Bracket
door electromechanick
1
Downloads
1
Likes
0
Makes
This is a bracket for mounting the Geekworm P252 Raspberry Pi 3B+ case to a wall or other surface.
Has two M3.5 size (#6 standard) mounting holes spaced at 40 mm center to center distance.
I printed it with 0.3 mm layer height at 100% infill with PLA and it is surprisingly durable.
The "no-fingers" variant has the small fingers that touch the top surface of the case removed; this should allow the mount to work on cases which have a flat top surface (as opposed to heatsink ridges).
Has two M3.5 size (#6 standard) mounting holes spaced at 40 mm center to center distance.
I printed it with 0.3 mm layer height at 100% infill with PLA and it is surprisingly durable.
The "no-fingers" variant has the small fingers that touch the top surface of the case removed; this should allow the mount to work on cases which have a flat top surface (as opposed to heatsink ridges).
electromechanick publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
