Thingiverse
Gem Dragon
door GrandpaJohnny
50
Downloads
147
Likes
0
Makes
Hello,
This is my first dragon. I made it in Tinkercad after watching a YouTube video on making dragons. It wasn't all that hard even though I know it is not as nice as a lot of the other dragons on here I think it still turned out pretty good. It prints just fine. I scaled it down to 70% to fit on my printer bed and the links all still move. I don't think I would go any smaller though because the last links by the tail are pretty small.
Hope you like it.
This is my first dragon. I made it in Tinkercad after watching a YouTube video on making dragons. It wasn't all that hard even though I know it is not as nice as a lot of the other dragons on here I think it still turned out pretty good. It prints just fine. I scaled it down to 70% to fit on my printer bed and the links all still move. I don't think I would go any smaller though because the last links by the tail are pretty small.
Hope you like it.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
