Tools
Ver Modelo
Generic caliper battery mod
422
Descargas
400
Likes
2
Makes
Replace the LR44 with a AAA battery for the Generic caliper. the battery is fiction fit with the bend on the side of the battery compartment.
You will need: wires, tinfoil, some type of glue and a multimeter
* Route 2 wires to the slot of the battery cap. Use a dab of glue to secure it in the slots.
* Glue a piece of tin foil to the bottom of the cap making sure the tinfoil is making contact with the wire
* Slide the cover onto the caliper
* Slot the cap into the cover, push it down and rotate anti-clockwise. The prong will hold it in place
* Slide the cover out abit and use a tool to pry the side prong towards the cap. then slide the cover back
* Route the wire to both end of terminals
* Add tinfoils to terminals
* optionally add a dab of glue to hold the wire flat and tinfoil down.
PS: There are 3 offset sizes for the battery cap, I use the 0.4mm, but I would recommend 0.5 or 0.6mm. Hot glue is your best friend here, use a flathead to smear the glue will help alot
You will need: wires, tinfoil, some type of glue and a multimeter
* Route 2 wires to the slot of the battery cap. Use a dab of glue to secure it in the slots.
* Glue a piece of tin foil to the bottom of the cap making sure the tinfoil is making contact with the wire
* Slide the cover onto the caliper
* Slot the cap into the cover, push it down and rotate anti-clockwise. The prong will hold it in place
* Slide the cover out abit and use a tool to pry the side prong towards the cap. then slide the cover back
* Route the wire to both end of terminals
* Add tinfoils to terminals
* optionally add a dab of glue to hold the wire flat and tinfoil down.
PS: There are 3 offset sizes for the battery cap, I use the 0.4mm, but I would recommend 0.5 or 0.6mm. Hot glue is your best friend here, use a flathead to smear the glue will help alot
feletoch también publica en
33 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!