Generic car audio Tweeter mount 1"

This STL is a generic tweeter mount. Which serves as a useful way to mount tweeters to interior panels of cars.
They will need a lot of fitting, sanding, painting to get them looking good. But with enough time and patience, the results can look quite good.

I designed and built this to hold the tweeters provided in a alpine Alpine S-S65C kit. The tweeters are 1" driver, 2" mounting hole, and 17.6mm deep from the front lip. Given that these are designed around this set of tweeters, I would highly recommend doing some test prints and measurements, as the fit is quite tight. And they may not work well for every vehicle and tweeter combination. The vehicle I fitted these to was a 2004 ford courier.

Print in a material that will withstand the hot temperatures that the vehicle interior can reach. I recommend PETG, since it is easy to print, and withstands up to 80C

Assembly.
To position and fit the part I used Blu-Tack, or poster putty to position the mounts while the trims ar