Thingiverse
Generic Dual Hooks (garage, etc)
door ssaggers
33
Downloads
15
Likes
1
Makes
Upgraded version of a hook that I did previously (for hanging a longboard), to suit use in my garage, specifically for hanging extension cords.
20mm wide. 45mm hook depth. see sketch in images for other dimensions.
Beefed up to 4mm thick - I recommend using ~5 perimeters (depending on perimeter width), so that the entire print is perimeters with minimal infill), for strength
Two screw holes (only need to use the top one, but use the second hole as well if you're hanging a heavy weight from the lower hook, as it helps take the bending out of the section between the hooks. Sized for tech-screw \ batten screws (6.5 mm diameter inscribed circle)
Hexagon holes to print without overhang defects.
Triangulated stiffening to give rigidity.
No supports required.
20mm wide. 45mm hook depth. see sketch in images for other dimensions.
Beefed up to 4mm thick - I recommend using ~5 perimeters (depending on perimeter width), so that the entire print is perimeters with minimal infill), for strength
Two screw holes (only need to use the top one, but use the second hole as well if you're hanging a heavy weight from the lower hook, as it helps take the bending out of the section between the hooks. Sized for tech-screw \ batten screws (6.5 mm diameter inscribed circle)
Hexagon holes to print without overhang defects.
Triangulated stiffening to give rigidity.
No supports required.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!