Thingiverse
Generic iPhone 6 Holder
por mattk007
22
Descargas
26
Likes
0
Makes
Mainly designed for in-car mounting, this is a generic iPhone 6 holder which can swivel and tilt.
Pins have a slight draft on them to allow them to be press fitted to fix position, or slightly loosened to allow re-positioning.
The pin at the bottom requires an 11mm diameter hole to fit into. For my application I designed a holder to fit into my car's coin tray, but you could choose a cup holder, air vent, etc. and just design a fitting with an 11mm hole.
When not mounted, it can also stand freely on a flat surface with your iPhone
Also included is a design to accommodate an Otter-Box iPhone cover, (will also work for most other covers)
Also now includes a Portrait version
Pins have a slight draft on them to allow them to be press fitted to fix position, or slightly loosened to allow re-positioning.
The pin at the bottom requires an 11mm diameter hole to fit into. For my application I designed a holder to fit into my car's coin tray, but you could choose a cup holder, air vent, etc. and just design a fitting with an 11mm hole.
When not mounted, it can also stand freely on a flat surface with your iPhone
Also included is a design to accommodate an Otter-Box iPhone cover, (will also work for most other covers)
Also now includes a Portrait version
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
