Thingiverse
Generic Quadcopter Wall Hook
by roguemat
19
Downloads
13
Likes
0
Makes
A simply mount that'll fit most small (up to about 250) quads. It requires a single small nail in the center. I used the 17.3mm x 1.6mm nails from some cable brackets.
There are two different depths. You should probably just print the long one to be safe.
Print with the hole facing the bed.
There are two different depths. You should probably just print the long one to be safe.
Print with the hole facing the bed.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
