Thingiverse
Generic VRM Fan Bracket
von Mechanicguy
4
Downloads
6
Likes
0
Makes
Many of the newest AIOs don't allow enough airflow to gaming PC mobo VRMs. This generic VRM fan bracket allowed me to connect a 60mm Noctua fan from the rear 120mm fan to cool the VRMs on the motherboard. It will hold most sizes of fan, I could connect two 60mm fans, if needed.
I used regular fan screws; however, my back fan had a slight vibration when the PLA was directly against it, so I used two tiny rubber offsets on the screws. Your experience may vary.
I used regular fan screws; however, my back fan had a slight vibration when the PLA was directly against it, so I used two tiny rubber offsets on the screws. Your experience may vary.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
