Slicer Discord
GenericCarMount Basket v1 – 3D-printbaar model van Thingiverse Thingiverse

GenericCarMount Basket v1

door dbeta
1 Downloads
5 Likes
0 Makes
Model downloaden
This is the basket to sit your phone in for a car mount. I'm still working out the specifics of the car mount point. I am using two part disconnecable mounting system from http://www.thingiverse.com/thing:4382 as soon as I figure out how to attach my phone to my car.

Ideally this should fit any smartphone that is wide enough and no thicker than a Galaxy S Vibrant or i9000's hump section. I would like to make it a little more generic but I also don't want to get in the way of the screen with tabs holding it in place.

The bottom is open to allow access to bottom facing usb ports, but it is not tested, so it may need to go further back. Input would be very welcome. If you have a Galaxy S you might find that the top tabs come a little too high and block access to the power and Vol- buttons, this was discovered after printing :(. I'm working on a fix.
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA, ABS
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie