Genesis Controller to USB Case

The 3mf file is provided for reference - DO NOT PRINT THIS! It contains a mock-up of the pico and dev board in it.

The Raspberry Pi Pico drives this project. This works with both 3 button and 6 button controllers.

Code and schematic may be found here: https://github.com/Tails86/GenesisControllerUsbPico

This case was designed without the need for any screws. The DB9 connectors snap into place, and the board is held in place by both the soldered on wires and the case itself.

Explanation of this project: https://www.youtube.com/watch?v=Fbt-3-cg1RE&t=32s

Potential issues:
The slots for the DB9 connector may be really tight when you first get it in there. Both ends need to be pushed in at the same time. If one goes in and the other doesn't, pry it out and try again. Use a thimble or some other blunt object to help you push it in because the edges of the connector are sharp. Your own adjustment may be necessary to work with your printer/plastic.

The top is tapered in the b