Geneva sculpture

I have always been fascinated with the beauty of intermittent motion, specifically the motion generated by a Geneva wheel and cam. one day i saw a Geneva mechanism hung on a wall at a museum of old machinery and I was inspired to make this design to create this you will need the following:5x Plastic Sleeve Housing for 2mm Shaft (these are not necessary, if you do not want them, simply glue the pins in place or someone might remix this to have tighter tolerances and not need the sleeves)2x D2 40mm stainless steel dowel pin2x D2 25mm stainless steel dowel pin1x N20 Single Shaft Worm Gear Motor1x Adafruit Downstream USB-C Breakout board~60mm of Wires to connect the USB-C to the motorTo assemble, follow the video below, however you do not need to insert the pegs into the cams, the pegs are now implemented into the cams to reduce assemblyTo install the motor you will need to de-solder the PCB from the motor's pins. Now you can connect, using wires, the positive pin on the motor to the p