Genie Remote Sleeve

My wife's Genie transmitter was intermittently opening the door when it was in her loaded purse. This sleeve slides over the buttons to prevent opening and closing fro minor contact. One face is thicker - we use that side over the buttons. You can still press the buttons with a hard press through the sleeve or slide it down and more easily locate and press the right button to actuate the door. I've attached a fusion 360 file if you would like to modify it.

I printed this in TPU 95A and recommend using a much slower print speed for TPU than you would use for PLA or PETG. I went through the slicer speed parameters and lowered everything by about 100 mm/sec - 150 became 50, etc. I also used 6 wall loops - it's mostly wall anyway. I ran it with a brim around the outside for better adhesion - not sure if it was needed or not. My other advice about printing in TPU is to be sure the filament is dry or you can get a stringy mess. It took me probably 20 hours in the drier before I started get